Furuno MFD8 Guia Do Utilizador

13.  How to Adjust Settings

You can show or hide all data boxes. Select [DataBox Display] at the bottom of the 
[DataBox-General] menu then push the RotoKey to show or hide all data boxes. You 
can also hide or show the data boxes with the DATA/VOL key.

You can adjust the degree of transparency for the data boxes with the [Transparency] 
slider. The available degree of transparency is 0-80(%). (Alpha blending technology is 
used for transparency effects.)

Section 1.5 shows how to select a display at the display selection window. The default 
display selection window provides five displays, identified as "hotpages," in configura-
tions according to the equipment that you have in your network. If the arrangement of 
the hotpages does not meet your requirements, you can change the hotpages as nec-
essary. You can select the number of hotpages to show from five to ten and split a 
hotpage up to four ways. For example, you can show the radar and fish finder displays 
in a two-way split screen.

You can select how to split a hotpage by four different methods: full-screen, two-way, 
three-way and four-way. The displays available depend on the screen division select-
ed and your system configuration. The table below describes screen division and pos-
sible display.

Set the number of hotpages to show on the display selection window as follows:

1. Press the MENU key to open the 

menu.

2. Open the [My NavNet-General] menu.
3. Use the RotoKey to select [Hotpage 

Number]. 

4. Use the RotoKey to select a number.
5. Press the MENU key to close the 

menu.

Full

Chart plotter, radar, camera, fish finder, weather facsimile

Two-way split

Chart plotter, radar, fish finder

Three-way split

Chart plotter, radar, fish finder

Four-way split

Chart plotter, radar, camera, fish finder, instrument