Avaya 9630 Guia Do Utilizador
Battery Charger
2-6
Issue 1 May 1999
Battery Charger Operations
This section explains how to choose a location for the battery charger, how to
install it, and how to insert and remove a battery pack.
install it, and how to insert and remove a battery pack.
Positioning the Battery Charger
You can place the battery charger on a desk or you can mount it on a wall. Before
you install the battery charger, do the following:
you install the battery charger, do the following:
■
Locate the battery charger within 5 ft (1.6 m) of a properly grounded
two-prong electrical outlet that is not controlled by an ON/OFF switch.
two-prong electrical outlet that is not controlled by an ON/OFF switch.
■
If your communications system uses an uninterruptable power supply, such
as a backup generator, you may want to connect the battery charger to that
power supply.
as a backup generator, you may want to connect the battery charger to that
power supply.
■
Do not locate the battery charger where it would be exposed to direct
sunlight or water.
sunlight or water.
!
WARNING:
Do not short-circuit or break the battery housing. (This may cause the
battery to overheat or smoke.) Do not burn or puncture the battery.
Like other batteries of this type, if it is burned or punctured, the
battery cell contents could spill onto the skin and cause irritation. Do
not dispose of the pack in household garbage. For information about
recycling or proper disposal, consult your local solid waste (garbage)
collection or disposal organization.
battery to overheat or smoke.) Do not burn or puncture the battery.
Like other batteries of this type, if it is burned or punctured, the
battery cell contents could spill onto the skin and cause irritation. Do
not dispose of the pack in household garbage. For information about
recycling or proper disposal, consult your local solid waste (garbage)
collection or disposal organization.
Installing the Battery Charger
NOTE:
If you are wall-mounting the battery charger, follow Steps 1 through 7. If you
are desk-mounting the battery charger, follow only Steps 1, 5, and 7.
are desk-mounting the battery charger, follow only Steps 1, 5, and 7.
1. Check to make sure the battery charger’s AC adapter is unplugged from
the wall outlet before continuing. If you are desk-mounting, skip to Step 5.
2. To wall-mount, place the battery charger’s wall-mounting template
(presented later in this chapter) against the wall. Choose a location backed
by a wooden stud (if unavailable, use toggle bolts instead of the supplied
wood screws). Hold the template straight; use a level if needed. If the
charger is not level, the battery pack may not make proper contact with the
charger.
by a wooden stud (if unavailable, use toggle bolts instead of the supplied
wood screws). Hold the template straight; use a level if needed. If the
charger is not level, the battery pack may not make proper contact with the
charger.
3. Mark the locations for the two wall-mounting screws, and then remove the
template from the wall. Lightly tap a nail into the wall to start the holes.