Magellan 210 Manual De Referência

1.

Press MENU.

2.

Use the Arrow joystick to highlight 

Preferences.

3.

Press ENTER.

4.

Use the Arrow joystick to highlight 

Reset Default.

5.

Press ENTER.

6.

Use the Arrow joystick to highlight 

All.

7.

Confirm.  Use the Arrow joystick to highlight 

Yes to confirm or No to cancel.

8.

Press ENTER. 

Alarms that you can set:

•

Beeper: The beeper is set to on by default to make an audible beep whenever a button (key) is pressed 

or when you are to be alerted by an alarm. You can turn off this feature through this screen.

•

Anchor - When you set the anchor alarm on, the eXplorist will alert you 

when it has moved a distance you have selected.  This could be used 

when you have anchored your boat and need to be alerted if it has 

drifted from it’s anchor point.

•

Arrival - The arrival alarm alerts you when you have arrived to the 

destination of each leg in your route or to a GOTO destination.  You will 

need to set the distance that you want to be alerted.  (Arrival alarms 

also use the speed you are traveling as a minor factor in computing 

when to provide the alarm.  If you have set the Arrival alarm to 250 feet 

and are traveling at 30 mph, the alarm will sound slighting before the 

250 foot mark.)

•

Off Course - When a route is active, the eXplorist computes when you have moved left or right of the 

plotted route.  You can set a distance, left or right of the plotted route, that when you exceed this 

distance you will be alerted by an alarm.  

•

GPS Fix - The GPS fix alarm is displayed when you have lost your GPS fix for more than 20 seconds.  

•

Proximity Alarm - The proximity alarm is very similar to the arrival alarm except that it factors in speed 

at a higher level than the arrival alarm.  The proximity alarm has two alerts.  First, when you are 

nearing the proximity alarm distance selected and second, a visual proximity alert when you are at the 

distance selected.

At the bottom of the display is a field that will display information about all alarms that have been triggered 
since the eXplorist was last turned on.

Note:  When an alarm is displayed, press ESC to clear the alarm from the screen.