Epson LQ-2080 Manual Do Utilizador

Changing Printer Settings From the Printer’s Control Panel

5-9

R4C3730
Rev. B

A5 size

CHAP5.FM

5/10/99

Pass 0

Proof Sign-off:
<Crestec>

_______

_______

_______

Font

You can select one of the following six fonts: OCR-B, Orator,
Orator-S, Script C, Roman T, and Sans Serif H. This font is then
used as the “other” font you can select using the Font button on
the printer’s control panel.

Roll paper

When you select On, the printer recognizes that you are using
roll paper and not single sheets, so it does not try to eject the paper
or advance it forward to the next page when you press the LF/FF
button.

Changing default settings

Follow the steps below to enter the default-setting mode and
change the printer’s default settings.

Note:
❏

To print the language selection and default-setting mode
instructions, you need three sheets of A4- or letter-size single-sheet
paper or three pages of continuous paper that is at least 279 mm
(11 in.) long and 210 mm (8.27 in.) wide. See Chapter 2 for
instructions on loading continuous paper, or Chapter 3 for
instructions on loading single sheets.

❏

If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet.

1. Make sure paper is loaded and the printer is turned off.

Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.