Epson C82 Guia De Configuração Rápida
1
Remove everything from the box.
2
Remove all the blue tape and packing material inside and around the printer.
The tape may be in slightly different places on your printer, so check carefully.
The tape may be in slightly different places on your printer, so check carefully.
3
Slide the paper support into the
grooves on either side of the sheet
feeder. The paper support should
fit securely.
grooves on either side of the sheet
feeder. The paper support should
fit securely.
Unpack
Unpack
Load Ink
Load Ink
1
Lower the printer’s output tray
and open the cover.
and open the cover.
2
Shake the package of ink cartridges four or five times. Then remove the cartridges
from the package. (Don’t shake them after removing the packaging.)
from the package. (Don’t shake them after removing the packaging.)
3
Lower each ink cartridge into its holder with the green circuit board facing the back.
Then gently push each ink cartridge down until it is firmly seated.
Then gently push each ink cartridge down until it is firmly seated.
The color of the cartridge label should match the marker on the holder.
4
Press the
ink button and close the printer cover.
The green power light flashes as your printer charges ink for about 90 seconds.
CAUTION: Don’t turn off the printer while the green power light is flashing,
unless the printer hasn’t moved or made any noise for more than 5 minutes.
unless the printer hasn’t moved or made any noise for more than 5 minutes.
Connect the Printer
Connect the Printer
Turn over
Printer cables are not included with your printer. You need
only one
of the following cables:
• USB cable (PC or Macintosh
®
)
or
• Parallel cable (PC only).
NOTE: If you have Windows
®
95 or NT 4.x, you must use a parallel cable.
USB Cable Users (PC or Mac)
1
Shut down your computer. In Windows, click
Start and select your Shut Down
or
Turn Off option.
Leave your computer turned off until section 6.
2
Plug the
square end of the cable into the USB port on the side of the printer.
(It’s right above the parallel port.)
3
Plug the
flat end of the cable into your computer’s USB port until it stops.
(You can use any open USB port.)
Parallel Cable Users (PC only)
1
Shut down your computer. Click Start and select your Shut Down or Turn Off option.
Leave your computer turned off until section 6.
2
Plug the end of the cable with the slotted connector into the parallel port on the side
of the printer, then secure it with the wire clips.
of the printer, then secure it with the wire clips.
3
Plug the end of the cable with the screws on the side into your computer’s
parallel port and secure it.
parallel port and secure it.
Power On
Power On
1
Plug the printer’s power cord into a grounded electrical outlet.
2
Press the printer’s
power button until the green power light comes on.
CAUTION: Use only the printer’s
power button to turn the printer on or off.
Power button
Ink button
Don’t touch the
green circuit boards
or remove any labels
green circuit boards
or remove any labels
Flat end
Square end
Slotted end
End with screws
Paper support
Printer
Ink cartridges
CD-ROM
Manual
1
1
3
3
2
2
4
4
Start
Here
Here
Start
Here
Here
EPSON Stylus
®
C82
EPSON Stylus C82
CPD-14293R1
4025621-01
CPD14293R1_Marg_SH_E.qxd 9/24/02 01:45 PM Page 1