Epson 7850p Ficha De Dados Do Produto

EPSON PowerLite 7850p Projector

6/03

EPSON PowerLite 7850p Projector 

- 

23

Follow these steps to replace the lamp and air filters:

1. Turn off the projector.

2. When the P power light stops flashing, unplug the power 

cord.

3. Let the projector cool for at least half an hour (if it has been 

on). The lamp is extremely hot immediately after use. 

4. Turn the projector upside-down and remove the air filters 

at the side and bottom of the projector.

5. Insert the two new air filters. They should click into place.

6. To remove the lamp cover, insert the screwdriver supplied 

with the spare lamp (or another flat-tipped screwdriver), 
into the space beside the air vent to gently lift the lamp 
cover off.

7. Loosen the two screws holding the lamp in place. (You 

don’t need to remove them.) 

8. Grasp the wire handle as shown and pull the lamp straight 

out. 

9. Gently insert the new lamp. 

10. Once the lamp is fully inserted, tighten its screws and 

replace the cover. (The projector won’t come on if the lamp 
cover is loose.) 

11. Reset the lamp timer as described in the next section. 

After you replace the lamp, you need to reset the lamp timer 
using the projector’s About menu. 

1. Press the 

Menu

 button on the remote control (or on the 

projector’s control panel). You see the main menu.

2. Use the 

pointer button on the remote control (or the 

arrow buttons on the projector) to highlight 

About

, then 

press 

Enter

. 

Slide the filter 
up here . . .

. . . and here

Lower the 
handle

1

Insert the screwdriver here