TallyGenicom 930 Guia Do Utilizador

Página de 54
E-32
Section 3
Operator Panel Function. Change to Limited Operation
to deactivate the PRINT QUALITY and CHARACTER
PITCH buttons. This prevents these from being changed
from the control panel when several people are using the
printer.
Page Length. Selects the length of the paper you are
using.
Page Width (wide model only). Change to 8" to print on
letter-size paper.
Paper Out Override. Senses when less than 1" (25 mm)
of paper remains and stops printing. Change to Yes to
override the sensor. Caution!! This can cause loss of
data and damage the printhead!
Pin 18. Sets the signal on pin 18 to +5 volts or to open.
Pitch. Choose the character width, in character per inch
(cpi).
Print Mode. Choose the quality and speed of printing.
Print Registration. Change the setting as required to
obtain the best registration for bi-directional printing.
Print Suppress Effective. If your system uses the DC1
and DC3 codes for something other than the print suppress
mode, change the setting to No.
Proportional Spacing. Change the setting to Yes to
engage proportional spacing of characters.
Receive Buffer Size. Selects the amount of memory
devoted to holding received data. Choosing 1 Line will tie up
your computer while printing, but if you abort the print job,
the printer will stop much sooner.
Reset Inhibit. Select Yes to prevent your software from
resetting your printer's settings.
SI Select Pitch, 10 cpi (IBM). Sets the pitch to be
engaged when the printer control panel is set for 10 cpi and
the SI command is received.
SI Select Pitch, 12 cpi (IBM). Sets the pitch to be
engaged when the printer control panel is set for 12 cpi and
the SI command is received.
Size. Change to Double for double width and height print-
ing.
Skip Over Perforation. Change to Yes if you want the
printer to go to the next page when it comes within 1" (25
mm) of the bottom of the page. Keep it set to No if your
software has its own page formatting controls.
Style. Change to italics if you want the printed characters
to be slanted.
Sec3.p65
10/3/97, 9:34 AM
32