Orange Amplifiers cr35ldx Guia Do Utilizador
PANEL FUNCTIONS
SPECIFICATIONS
FRONT PANEL
REAR PANEL
FUNCTION DESCRIPTIONS
1- INPUT : Use this jack to connect your guitar to the amplifier by means of a shielded instrument cable.
2- GAIN : This controls pre-gain level.
3- OVERDRIVE SWITCH : Use this switch to select the Overdrive (switch depressed) or Clean channel(switch in the out position).
4- OVERDRIVE LEVEL : This controls the amount of distortion ranging from overdrive to high gain.
2- GAIN : This controls pre-gain level.
3- OVERDRIVE SWITCH : Use this switch to select the Overdrive (switch depressed) or Clean channel(switch in the out position).
4- OVERDRIVE LEVEL : This controls the amount of distortion ranging from overdrive to high gain.
8- VOLUME : Controls the overall volume of the amplifier.
5- HIGH : Provides high frequency equalization as required.
6- MID : Provides middle frequency equalization with cut and boost.
7- LOW : Provides low frequency equalization as required.
6- MID : Provides middle frequency equalization with cut and boost.
7- LOW : Provides low frequency equalization as required.
9- AUX IN : Use this 1/8" stereo mini jack to connect the output of a CD or,MP3 player,Laptop,etc.,to the amp.(The jacks are internally summed to a mono signal).
10- HEADPHONE : For use with most stereo headphones.
11- POWER INDICATOR : LED indicates whether the power switch is ON or OFF.
12- FX MODE : Use this control select the type of FX effects applied to the output signal. each effect and its location is called out by the markings around the control.
13- FX LEVEL : Use this control to set the amount of digital effect applied to the output signal.
10
9
11
8
7
6
5
4
3
16
17
OUTPUT POWER
SPEAKER
INPUT
INPUT SENSITIVITY
NOISE
DXF EFFECT
FOOT S/W JACK
& PUSH SWITCH
& PUSH SWITCH
HEADPHONE
JACK LEVEL
POWER
CONSUMPTION
POWER
REQUIREMENT
DIMENSIONS
(W)X(H)X(D)
WEIGHT
CABINET
COLOR & FINISH
35 Watts RMS
@ 1% THD, 4 ohm
350mV @ 35W
(Headphone Impe. 8 ohm)
100V,120V,230V-
240V, 50/60Hz
10.9x14.5x8.9 inch
430x370x225 mm
Sturdy
Particleboard
Orange
Leatherette
Normal 48mV F=1KHz,
Volumes Tone Controls at Max
-25dB(Vol Max/M.Vol Max)
-55dB(Vol Max/M.Vol Min)
-30dB(Vol Max/M.Vol Min/Rev.Max)
-55dB(Vol Max/M.Vol Min)
-30dB(Vol Max/M.Vol Min/Rev.Max)
1X 10"
Guitar and AUX
16 programs
95VA
25.3 lbs.(11.5kg)
CAUTION: To avoid possible damage to your hearing, do not use headphones for extended periods of time at extremely loud levels.
2
1
13
12
15
14
14- TUNER LED : This LEDs the tuning guide LEDs.
15- TUNER SWITCH : This push switch turns the Tuner On/Off.
16- AC MAIN POWER SWITCH : This switch turns the AC Main Power ON or OFF.
16- AC MAIN POWER SWITCH : This switch turns the AC Main Power ON or OFF.
17- AC INLET & FUSEHOLDER : Connect the supplied standard 3-pin 'IEC' plug here.
18
19
18- OVERDRIVE PEDAL :Use this jack connect the footswitch to enble remote on/off switching of the overdrive.
OverDrive
Pedal Switch
19- LINE OUTPUT : Use this unbalanced jack to send a line level signal to another amplifier, the mixung board, or recording consol.