Gateway 310 aafes Guia Do Utilizador
170
Chapter 11: Upgrading Your Computer
www.gateway.com
4
If you are adding a new drive, remove the drive bay cover from the drive
bay where you want to install the new drive.
bay where you want to install the new drive.
- OR -
If you are replacing a drive, lift the drive release latch up and slide the
drive forward and out of the drive bay.
drive forward and out of the drive bay.
5
Set the drive jumpers, if necessary. See the drive documentation for further
instructions.
instructions.
6
Slide the new drive into the drive bay. Push firmly until the drive release
latch locks the drive into place.
latch locks the drive into place.
7
Reconnect the drive cables using your notes from
. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side closest to the power supply connection).
See the drive documentation for further instructions.
on the drive (typically on the side closest to the power supply connection).
See the drive documentation for further instructions.
8
Close the case by following the instructions in
.