Studiologic mp-113 Guia Do Utilizador

Página de 2
Welcome to the world of STUDIO LOGIC MIDICONTROLLERS.
the MIDI MP-113/MP-117 is a MIDI Pedalboard controller with a simple yet versatile
software.Studio and stage musicians alike will appreciate the added flexibility of acces-
sing MIDI events by foot, both for playing traditional bass lines and for triggering other
MIDI effects and devices.
TECHNICAL DATA
The MP-113/MP-117 pedalboard is composed of:
•Pedalboard with 13 (MP-113) or 17 (MP-117) dynamic keys
• Top panel with the following buttons: MIDI channel. Program Change, Bank Select and
Transpose ^
• 1 zone with full extension
• Numerical keypad corresponding to the pedals starting from the first low C.
• Rear panel: 1 output MIDI, DC feeding input, 1 signaling led.
CONNECTIONS
1) Connect the AC adapter cable to the power input jack. Make sure that the AC adapter
corresponds to the correct voltage output. The MP-113/MP-117 will accept an adapter
that has a rating of 9V DC with a positive polarity and has a minimum current of 200 mA.
2) Connect MIDI cable/s to the MIDI input on your sound sources.
3) Connect the DC feeding cable to the MIDI pedalboard. The default channel is MIDI no.l.
TOP PANEL
The figure shows the control panel on top of the pedalboard, with four function buttons.
To assign values and adjust parameters, use the numerical keypad located on the PEDAL-
BOARD octave. Starting from the LOW C, you will have the following pattern:
MIDI FUNCTIONS
You should bear in mind the main functions of your Pedalboard.
A few seconds after switching on, the instrument is ready to send the desired MIDI data
and the keyboard will be sending on MIDI channel no. 1.
Operations must be carried out sequentially. To assign values to commands, hold the spe-
cific button, enter the number on the keypad and then release the button. If there are any
keys pressed on the keyboard, no command will be accepted. The same happens when the
Sustain pedal is down. On the contrary, if you press any key no sound is produced, since
the function keys on the central octave are enabled.
When you switch on your instrument, it will send the following data:
•VOLUME = VALUE 127
•PITCH BEND = VALUE 64