KYOCERA 2345 Guia Do Utilizador

Página de 64
FCC/IC Notice
This device complies with part 15 of the FCC rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation. 
To comply with FCC radiation exposure 
requirements, use of this device for body-worn 
operational configurations is limited to accessories 
tested and approved by Kyocera Wireless Corp. 
(KWC). Other accessories used with this device for 
body-worn operations must not contain any metallic 
components and must provide at least 22.5 mm 
separation distance including the antenna and the 
user’s body.
This model phone meets the government’s 
requirements for exposure to radio waves.
Your wireless phone is a radio transmitter and 
receiver. It is designed and manufactured not to 
exceed the emission limits for exposure to radio 
frequency (RF) energy set by the Federal 
Communications Commission of the U.S. 
Government. These limits are part of comprehensive 
guidelines and establish permitted levels of RF 
energy for the general population. The guidelines 
are based on standards that were developed by 
independent scientific organizations through 
periodic and thorough evaluation of scientific 
studies. The standards include a substantial safety 
margin designed to assure the safety of all persons, 
regardless of age and health.
The exposure standard for wireless mobile phones 
employs a unit of measurement known as the 
Specific Absorption Rate, or SAR. The SAR limit set 
by the FCC is 1.6 W/kg.* Tests for SAR are conducted 
using standard operating positions specified by the 
FCC with the phone transmitting at its highest 
certified power level in all tested frequency bands. 
Although the SAR is determined at the highest 
certified power level, the actual SAR level of the 
phone while operating can be well below the 
maximum value. This is because the phone is 
designed to operate at multiple power levels so as to 
use only the power required to reach the network. In 
general, the closer you are to a wireless base station 
antenna, the lower the power output. 
Before a phone model is available for sale to the 
public, it must be tested and certified to the FCC that 
it does not exceed the limit established by the 
government-adopted requirement for safe exposure. 
The tests are performed in positions and locations 
(e.g., at the ear and worn on the body) as required by 
the FCC for each model. The highest SAR values for 
this model phone are:
AMPS
 modeHead: 1.24 mW/g; Body-worn: 
0.250 mW/g with KWC body-worn accessory.
PCS mode
Head: 1.24 mW/g; Body-worn: 
0.195 mW/g with KWC body-worn accessory. 
(Body-worn measurements differ among phone 
models, depending upon available accessories and 
FCC requirements). While there may be differences 
between the SAR levels of various phones and at 
various positions, they all meet the government 
requirement for safe exposure.
The FCC has granted an Equipment Authorization for 
this model phone with all reported SAR levels 
evaluated as in compliance with the FCC RF emission 
guidelines. SAR information on this model phone is 
on file with the FCC and can be found under the 
Display Grant section 
http://www.fcc.gov/oet/fccid
 after searching on FCC 
ID OVFKWC-2345. Additional information on SAR 
can be found on the Cellular Telecommunications 
and Internet Association (CTIA) Web site at 
http://www.wow-com.com
* In the United States and Canada, the SAR limit for 
mobile phones used by the public is 1.6 watts/kg 
(W/kg) averaged over one gram of tissue. The