KYOCERA FS-2000D Guia De Utilização

This printer is equipped with a parallel interface, a USB interface and a 
network interface (FS-3900DN/FS-4000DN). An optional serial interface 
and a network interface can be installed. Various printing environment 
parameters such as the default emulation can be changed independently 
on different interfaces by using the printer’s menu selection system. Select 
the interface to apply the changes in the procedure described below.

This interface selection described below does not select the 

interface from which data will be received. The printer automatically 
selects the interface

The parallel interface supports a bi-directional/high-speed mode according 
to IEEE standards. Normally, this interface is used under the default setting 
Auto

. For details, refer to Parallel Interface on page 4-3. After setting the 

interface, be sure to reset the printer or turn the power off at least once. 
The new setting will be enabled thereafter. You can select from the 
following:

•

Auto (default)

•

Nibble (high)

•

High speed 

•

Normal

Press [Menu].

Press  ? or @ repeatedly until Interface > appears. 

If the interface is other than parallel, press 
[OK]. A blinking question mark (?) appears.

Press  ? or @ repeatedly until Parallel 
appears.

Press [OK] again. The question mark disappears.

To change the parallel interface mode, press B. The current 
communication mode appears.

To change the communication mode, press 
[OK]. A blinking question mark (?) appears.

Interface      

? Serial

Interface      

? Parallel

>Parallel I/F

? Nibble (high)