KYOCERA FS-2000D Guia De Utilização
Using the Operation Panel
ADVANCED OPERATION GUIDE
2-33
Changing Network Interface Parameters
This printer supports TCP/IP, NetWare and AppleTalk protocols. In
addition, you can install the optional network interface card in the option
interface slot.
addition, you can install the optional network interface card in the option
interface slot.
NOTE:
Installing the optional network interface card on the FS-2000D
enables the following network settings.
Using the operation panel, you can:
•
Activate or deactivate TCP/IP, NetWare, and AppleTalk
•
Activate or deactivate DHCP
•
Enter IP address, subnet mask address, and default gateway address
•
Determine whether to print a network status page when the printer is
turned on
turned on
1
Press [Menu].
2
Press ? or @ repeatedly until Interface > appears.
3
If the current interface is other than
Network
Network
, press [OK]. A blinking question
mark (?) appears.
If the optional network interface card is
installed in the printer, Option will be displayed. The setting procedure is
basically the same even in this case.
installed in the printer, Option will be displayed. The setting procedure is
basically the same even in this case.
4
Press ? or @ repeatedly until Network
appears.
appears.
5
Press [OK] again.
Interface >
? Parallel
Interface >
? Network