KYOCERA FS-2000D Guia De Utilização
Using the Operation Panel
2-62
ADVANCED OPERATION GUIDE
The operations of the RAM disk are the same as those of the
CompactFlash card. Refer to the relevant sections in Using the
CompactFlash Card on page 2-54. When data is written to the RAM disk,
the name automatically given to the corresponding file will be DataH001
(for the 1st file), DataH002 (for the 2nd file), DataH003 (for the 3rd file), etc.
CompactFlash card. Refer to the relevant sections in Using the
CompactFlash Card on page 2-54. When data is written to the RAM disk,
the name automatically given to the corresponding file will be DataH001
(for the 1st file), DataH002 (for the 2nd file), DataH003 (for the 3rd file), etc.
NOTE:
The RAM disk can not be used when an Microdrive is installed.
The RAM disk stores data only temporarily. When the printer is reset or
turned off, the stored data will be erased.
The RAM disk is allocated within the printer's memory available to users.
If the size of the RAM disk is set too large, the printing speed may
decrease or the memory may become insufficient.
turned off, the stored data will be erased.
The RAM disk is allocated within the printer's memory available to users.
If the size of the RAM disk is set too large, the printing speed may
decrease or the memory may become insufficient.
Setting the RAM Disk Size
1
Press [Menu].
2
Press ? or @ repeatedly until RAM Disk
Mode>
Mode>
appears.
3
Press [OK]. A blinking question mark (?)
appears. Press ? or @ to select On. Press
[OK].
appears. Press ? or @ to select On. Press
[OK].
4
Press B. Press ? or @ repeatedly until
>RAM Disk Size
>RAM Disk Size
appears. The data size
also appears.
5
Press [OK]. A blinking cursor (_) appears.
Press ? or @ to display the desired size.
Definable RAM disk size is 0001 to 1024.
Press ? or @ to display the desired size.
Definable RAM disk size is 0001 to 1024.
This range varies depending on the total
memory size of the printer. The setting exceeding this range is
automatically adjusted to the maximum RAM disk size.
memory size of the printer. The setting exceeding this range is
automatically adjusted to the maximum RAM disk size.
6
When the desired RAM disk size is displayed, press [OK].
7
Press [Menu]. The display returns to Ready. Turn the printer off and then
on again. The selected RAM disk size is activated after the printer is
restarted.
on again. The selected RAM disk size is activated after the printer is
restarted.
RAM Disk Mode
Off
RAM Disk Mode
? On
>RAM Disk Size
0156 MByte
>RAM Disk Size
0156 MByte