Viewsonic PJD6243 Manual Do Utilizador
29
6. Please wait for around 15 - 20 seconds, and then re-enter the Lan control setting
page. The IP address, Subnet Mask, Default Gateway, and DNS settings will be
displayed. Note down the IP address displayed in the IP address row.
displayed. Note down the IP address displayed in the IP address row.
Important
• If the Projector IP Address still does not appear, contact your network administrator.
•
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
•
If you need to connect to the projector in its standby mode, set Power Saving to Off.
If you are in a non-DHCP environment:
1. Repeat steps 1-3 above.
2. Press
1. Repeat steps 1-3 above.
2. Press
to highlight DHCP and press / to select Off.
3. Contact your ITS administrator for information on the IP address, Subnet Mask,
Default Gateway, and DNS settings.
4. Press to select the item you want to modify and press Enter on the remote
control.
5. Press / to move the cursor and the enter the value.
6. To save the settings, press Enter on the remote control. If you do not want to save
6. To save the settings, press Enter on the remote control. If you do not want to save
the settings, press MENU/EXIT on the projector or Menu on the remote control.
7. Press to highlight Apply and press Enter on the remote control.
Important
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
connected and perform the procedures above again.
•
If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.
Controlling the projector remotely through a web
browser
browser
Once you have the correct IP address for the projector and the projector is on or in
standby mode, you can use any computer that is on the same local area network to
control the projector.
standby mode, you can use any computer that is on the same local area network to
control the projector.
•
If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.
•
The screen shots in this manual are for reference only, and may differ from the actual
design.
design.
1. Enter the address of the projector in the address bar of your browser and press
Enter.