Viewsonic PJD5132 Manual Do Utilizador
54
4.
Loosen the screw that secures the lamp.
5.
Disconnect the lamp’s wire connector from
the projector, and then lift the handle so that
it stands up. Use the handle to slowly pull
the lamp out of the projector.
the projector, and then lift the handle so that
it stands up. Use the handle to slowly pull
the lamp out of the projector.
CAUTION
•
Pulling it too quickly may cause the lamp to
break and scatter broken glass in the projector.
break and scatter broken glass in the projector.
•
Do not place the lamp in locations where water
might splash on it, children can reach it, or
near flammable materials.
might splash on it, children can reach it, or
near flammable materials.
•
Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause color
unevenness and distortion of the projected
images.
after the lamp is removed. If you touch the
optical components inside, it could cause color
unevenness and distortion of the projected
images.
6.
Insert the new lamp into the lamp
compartment and make sure it fits in the
projector. Connect the new lamp’s wire
connector to the projector.
compartment and make sure it fits in the
projector. Connect the new lamp’s wire
connector to the projector.
7.
Tighten the screw that secures the lamp.
CAUTION
•
Loose screw may cause a bad connection,
which could result in malfunction.
which could result in malfunction.
•
Do not over tighten the screw.
8.
Ensure the handle is fully laid flat and
locked in place.
locked in place.
1
2
3