Sony HCD-DJ2i Manual
40
GB
Troubleshooting
Should you encounter a problem with
your system, do the following:
your system, do the following:
1
Make sure the power cord and
speaker cords are connected
correctly and firmly.
speaker cords are connected
correctly and firmly.
2
Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists after doing all of
the above, consult your nearest Sony
dealer.
the above, consult your nearest Sony
dealer.
Note that if service personnel changes
some parts during repair, these parts may
be retained.
some parts during repair, these parts may
be retained.
In the event of a problem, have a Sony
dealer check the entire system together.
dealer check the entire system together.
General
The display starts flashing as soon as
you plug in the power cord even
though you have not turned on the
system.
you plug in the power cord even
though you have not turned on the
system.
• The demonstration mode started. Press
"/1
The clock or timer setting is canceled.
• The power cord is disconnected or a
power failure occurred. Redo “Setting
the clock” (page 17). If you have set the
timer, redo “Using the timer” (page 38).
the clock” (page 17). If you have set the
timer, redo “Using the timer” (page 38).
“– –:– –” appears in the display.
• The clock is not set. Set the clock
(page 17).
• A power failure has occurred. Set the
Additional Information
When the STANDBY indicator
flashes
flashes
Immediately unplug the power cord
on the subwoofer and check the
following items.
• If your subwoofer have a voltage
on the subwoofer and check the
following items.
• If your subwoofer have a voltage
selector, is the voltage selector set to
the correct voltage?
Check the voltage for your region,
then make sure the voltage selector
is set correctly.
the correct voltage?
Check the voltage for your region,
then make sure the voltage selector
is set correctly.
• Are the + and – speaker cords short-
circuited?
• Are you using the supplied
speakers?
• Is anything blocking the ventilation
holes on the rear of the unit?
After checking the above items and
fixing any problems, plug in the power
cord again and turn on the system. If
the STANDBY indicator still flashes,
or if the cause of the problem cannot
be found even after checking all the
above items, consult your nearest
Sony dealer.
fixing any problems, plug in the power
cord again and turn on the system. If
the STANDBY indicator still flashes,
or if the cause of the problem cannot
be found even after checking all the
above items, consult your nearest
Sony dealer.