KitchenAid KDRS483VSS Guia Da Instalação

Electrical Requirements – Canada Only

If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrical installer determine 

that the ground path and wire gauge are in accordance with 

local codes.
Be sure that the electrical connection and wire size are adequate 

and in conformance with the CSA Standard C22.1, Canadian 

Electrical Code, Part 1 - latest edition, and all local codes and 

ordinances.
A copy of the above code standards can be obtained from:

Canadian Standards Association 

178 Rexdale Blvd. 

Toronto, ON M9W 1R3 CANADA

 

■

Check with a qualified electrical installer if you are not sure 

the range is properly grounded.

 

■

When a 4-wire, single-phase 250-volt, 60 Hz., AC-only 

electrical supply is available, a 40-amp minimum circuit 

protection is required on 30" (76.2 cm) and 36" (91.4 cm) 

ranges and a 50-amp minimum circuit protections is required 

on 48" (121.9 cm) ranges, fused on both sides of the line.

 

■

A time-delay fuse or circuit breaker is recommended.

 

■

This range is equipped with a CSA International Certified 

Power Cord intended to be plugged into a standard 14-50R 

wall receptacle. Be sure the wall receptacle is within reach 

of range’s final location.

 

■

Do not use an extension cord.

Gas Supply Requirements

Observe all governing codes and ordinances.
IMPORTANT: This installation must conform with all local codes 

and ordinances. In the absence of local codes, installation must 

conform with American National Standard, National Fuel Gas 

Code ANSI Z223.1/NFPA 54 - latest edition or CAN/CGA B149 - 

latest edition.
IMPORTANT: Range cooktop must be connected to a regulated 

gas supply.
IMPORTANT: Leak testing of the range cooktop must be 

conducted according to the manufacturer’s instructions.

Natural Gas:
This range is factory set for use with Natural gas. The model/

serial/rating plate located on the right vertical surface of the oven 

door frame has information on the types of gas that can be used. 

If the types of gas listed do not include the type of gas available, 

check with the local gas supplier.
LP Gas Conversion:
Conversion must be done by a qualified service technician.
No attempt shall be made to convert the range cooktop from 

the gas specified on the model/serial/rating plate for use with 

a different gas without consulting the serving gas supplier. To 

convert to LP gas, use the LP gas conversion kit provided with 

your range and see the “Gas Conversions” section. The parts for 

this kit are in the literature package supplied with the range.