KitchenAid KDRS483VSS Guia Da Instalação

Install Grill Grease Trays

(on grill models)

1.  Remove flame spreader. Pull forward slightly on the flame 

spreader to release the tabs from the rear slots and lift out.

2.  Cut and remove tie strap from rear of burner assembly.

3.  Lift burner assembly up and out to remove.
4.  Slide drip tray into opening on the right front side of the grill 

basin. There are guides to assure correct placement of the 

drip tray.

5.  Insert the large grease tray all the way under the back edge 

of the grill basin and hook it into the slots.

6.  Insert the small grease tray all the way under the front 

of the grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small 

grease tray will hook over the large grease tray.

7.  Insert the orifice tube on the front of the burner assembly 

into the opening at the front of the grill basin and set burner 

assembly into place.

8.  Insert front tabs of the flame spreader into slots at the front 

of the grill basin, then the rear tabs into the rear slots.

9.  Check the surface burner and grill flames. Refer to the 

“Electronic Ignition System” section.

10. Place the wave tray on top of the flame spreader.

11. Place the grill grate into position.