KitchenAid 27" Double Wall Oven with Even-Heat™ True Convection Instrução De Instalação

1.  Using two hands, grasp side edges of door at the midpoint. 

Face the oven cavity.

2.  Locate the slots on each side of the oven cavity for the door 

hinge locks.

3.  At a 45° angle, align door hinges with slots in the lower 

front of the oven cavity. Slowly insert door, making sure you 

maintain the 45° angle. You will know the door is engaged 

in the slot when you feel a slight drop.

4.  Lower the oven door to the fully open position. If the oven 

door does not open to a full 90 degrees, repeat steps 1 

through 3.

5.  Locate the oven door hinge locks in the corners of the oven 

door, and rotate the hinge locks toward the oven cavity to 

the locked position.
See Step 3 (illustration A) in the “Remove Oven Door(s)” 

section for proper locked position.

6.  Close the oven door.
7.  When the hinges are properly installed and the door closed, 

there should be an even gap between the door and the 

control panel. If one side of the oven door is hanging lower 

than the other, the hinge on that side is not properly installed. 
Repeat the steps to remove, then replace the oven door. See 

“Remove Oven Door(s)” and “Replace Oven Door(s).”

The positioning of the oven feet allows a single oven to be 

installed in a recommended cutout height of 28

1

/

2

" (72.4 cm).

Go to the “Make Electrical Connection” section in the Installation 

Instructions provided with your built-in oven.

The oven feet need to be installed to allow a double oven to be 

installed in a recommended cutout height of 51

7

/

16

" (130.6 cm).

NOTE: Do not remove the spacers.