KitchenAid 27" Double Wall Oven with Even-Heat™ True Convection Guia Da Instalação

5. The bottom vent and bottom vent trim (required when the 

oven is installed with the feet in the tall position) are shipped 
in the foam packing at the top of the oven. 

To install only the bottom vent, see the following instructions. 
To install both the bottom vent and the bottom vent trim for 
installations with the feet in the tall position, see the 
instructions in Step 6.

■

Align vent tab (B) with oven frame (A) as shown.

■

Using one #8-18 x 

³⁄₈" screw (D) on each side of the vent 

tab (B), fasten the vent securely to the oven.

6. On models with the feet installed in the tall position, the 

bottom vent trim must also be installed. See the following 
instructions to install.

■

Flex the upper vent piece (C) away from the lower vent 
piece (D) to slide the bottom vent trim (B) between them. 
Some force may be required to flex the upper vent trim (C) 
away from the lower vent trim (D). Some force may also 
be required to flex the bottom vent trim (B) and slide it 
into position. Make sure screw holes are properly aligned 
between the two pieces. See the following illustration. 

■

Install the bottom vent trim (B) to the lower vent piece (D) 
using two #8-18 x 

¹⁄₄

" screws on each side.

NOTE: On 27" (68.6 cm) models, only one #8-18 x 

¹⁄₄

" screw is 

used on each side.

■

Align vent tab (B) with oven frame (A) as shown.

■

Using one #8-18 x 

³⁄₈" screw (E) on each side of the vent 

tab (B), fasten the vent securely to the oven.

7. Replace the oven racks.

8. Replace the oven door. See the “Replace Oven Door(s)” 

section.

9. Check that the door is free to open and close. If it is not, 

repeat the removal and installation procedures. See the 
“Prepare Built-In Oven” section.

10. Repeat for lower oven door.

11. Reconnect power.

12. The display panel will light briefly, and “PF” should appear in 

the display.

13. If the display panel does not light, reference the “Warranty” 

section of the Use and Care Guide.

On single and double oven models installed above a warming 
drawer, a warming drawer deflector kit must be installed. See the 
“Tools and Parts” section for information on ordering.

³⁄₈

¹⁄₄

A

C

D

B

D

B

A

C

B

D

C

³⁄₈

A

C

D

B

E

B

A