KitchenAid 27" Single Wall Oven with Even-Heat™ Thermal Bake/Broil Instrução De Instalação

This assembly is required for use when a single or double 

built-in oven is installed in a flush installation.
1.  Flex the upper vent piece (C) away from the lower vent 

piece (D) to slide the deflector bracket (B) between them. 

Some force may be required to flex the upper vent trim (C) 

away from the lower vent trim (D). Some force may also 

be required to flex the deflector bracket (B) and slide it 

into position. Make sure screw holes are properly aligned 

between the two pieces. See the following illustration.

2.  Install the deflector bracket (B) to the lower vent piece (D) 

using two #8-18 x 

1

/

4

" screws on each side.

NOTE: On 27" (68.6 cm) models, only one #8-18 x 

1

/

4

" 

screw is used on each side.

3.  Align vent tab (B) with oven frame (A) as shown in the 

following illustration.

4.  Using one #8-18 x 

3

/

8

" screw (E) on each side of the vent 

tab (B), fasten the vent securely to the oven.

5.  Replace the oven racks.
6.  Replace the oven door. See the “Replace Oven Door(s)” 

section.

7.  Check that the door is free to open and close. If it is not, 

repeat the removal and installation procedures. See the 

“Prepare Built-In Oven” section.

8.  Repeat for lower oven door.
9.  Reconnect power.
10. The display panel will light briefly, and “PF” should appear 

in the display.

11. If the display panel does not light, refer to the “Assistance 

or Service” section of the Use and Care Guide provided 

with your built-in oven or contact the dealer from whom you 

purchased your oven.

1.  Check that all parts are now installed. If there is an extra 

part, go back through the steps to see which step was 

skipped.

2.  Check that you have all of your tools.
3.  Dispose of/recycle all packaging materials.
4.  For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Ovens
1.  Turn on power.
2.  At first use, set up the clock and any other preferences 

if available. For more information, read the Use and Care 

Guide.

3.  Press BROIL on single oven models.

NOTE: Press UPPER BROIL or LOWER BROIL on double 

oven models.

4.  Set the temperature.
5.  Press START.
If oven(s) does not operate, check the following:

 

■

Household fuse is intact and tight, or circuit breaker has 

not tripped.

 

■

Electrical supply is connected.

 

■

See “Troubleshooting” section in the Use and Care 

Guide.

6.  When oven has been on for 5 minutes, feel for heat. 

If you do not feel heat or if an error message appears in the 

display, turn off the oven and contact a qualified technician.

7.  Press UPPER CANCEL/LOWER CANCEL on double ovens, 

or press CANCEL on single ovens.

If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use 

and Care Guide or contact the dealer from whom you purchased 

your built-in oven.