Nikon SB-N10 Manual Do Utilizador
23
En
2
Adjust fl ash unit settings.
Rotate the mode dial to TTL.
Rotate the mode dial to TTL.
3
Take pictures.
If fl ash output was adjusted successfully, the fl ash-ready
lamp will light green for about two seconds after the fl ash
has fi red. If the lamp does not light, adjust the distance to
the subject and try again.
If fl ash output was adjusted successfully, the fl ash-ready
lamp will light green for about two seconds after the fl ash
has fi red. If the lamp does not light, adjust the distance to
the subject and try again.
Flash output can be adjusted using
the fl ash-level dial. Rotate the dial
clockwise to increase fl ash output,
counterclockwise to decrease.
the fl ash-level dial. Rotate the dial
clockwise to increase fl ash output,
counterclockwise to decrease.
A
If the Flash-Ready Lamp Lights Blue
If the fl ash-ready lamp lights blue, press
the targeting lamp button until the lamp
changes color (about three seconds) to show
that fl ash-compensation support is enabled
(
the targeting lamp button until the lamp
changes color (about three seconds) to show
that fl ash-compensation support is enabled
(
0
5).
A
Disabling the Flash
The fl ash can be disabled by rotating the mode dial to OFF and setting
the camera fl ash mode to
the camera fl ash mode to
s
(off ).