Nikon WT-3A (D200) Manual Do Utilizador
51
Troubleshooting
Problem
Solution
“POWER” LED does not light.
• Confi rm that battery is inserted in WT-3 and is fully
charged.
• Reattach WT-3.
• Insert memory card (transfer and print modes
• Insert memory card (transfer and print modes
only).
• Turn camera on.
• Press shutter-release button halfway to activate ex-
• Press shutter-release button halfway to activate ex-
posure meters.
• Select On for Wireless transmitter > Wireless
LAN system option in camera setup menu.
• Open connection to printer (print mode only).
20
18
21, 30
—
—
—
34
31
All LEDs blink at once.
WT-3 hardware error. Contact a Nikon-authorized
service representative.
service representative.
25, 29,
31
Wireless transmitter option
not available.
not available.
• Reattach WT-3.
• Select PTP for USB option in camera setup menu.
• Select PTP for USB option in camera setup menu.
18
11
11
Excessive radio interference.
Change orientation of camera or antenna.
4
Camera displays “Ethernet ca-
ble is not connected.”
ble is not connected.”
Connect Ethernet cable or change interface setting
to Wireless & Ethernet.
to Wireless & Ethernet.
4, 13,
49
Camera displays wireless error.
• Confi rm that host and wireless LAN adapter are on.
• Ensure that there are no obstacles between WT-3
• Ensure that there are no obstacles between WT-3
and wireless LAN adapter.
• Check settings for host and / or wireless LAN adapter
and adjust camera settings appropriately.
—
—
—
14, 35
Camera displays TCP/IP or FTP
error.
error.
• Check settings for host and / or wireless LAN adapter
and adjust camera settings appropriately.
• Check fi rewall settings.
14, 35
16, 48
Memory card error displayed.
Confi rm that memory card is properly inserted.
21, 30
Photos can not be trans-
ferred to computer to which
PictureProject has been in-
stalled.
ferred to computer to which
PictureProject has been in-
stalled.
• PictureProject version is incorrect. Update to latest
version or install version supplied with D200.
• Macintosh: If PictureProject was installed after WT-3
Setup Utility, reinstall WT-3 Setup Utility.
—
Transfer interrupted before all
photographs are sent.
photographs are sent.
Transfer will resume if camera is turned off and then
on again, exposure meters are reactivated, or On for
Wireless transmitter > Wireless LAN system.
on again, exposure meters are reactivated, or On for
Wireless transmitter > Wireless LAN system.
34
Error displayed stating that no
images are available for print-
ing.
images are available for print-
ing.
Only JPEG images can be printed from the camera.
Transfer RAW (NEF) images to computer and print
them from PictureProject or Nikon Capture version
4.4 or later.
Transfer RAW (NEF) images to computer and print
them from PictureProject or Nikon Capture version
4.4 or later.
—