Canon XH A1S Manual De Instruções

109

Pl
ayback

Returning to a Pre-marked Position

If you wish to return to a particular scene later, mark the point with the zero set memory, and the tape
will stop at that point when you rewind/fast forward the tape.

This function is operated with the wireless controller.

1. During playback, press the ZERO SET MEMORY button at the point you wish to return

to later.

• The tape counter is reset to 0:00:00 and the

mark appears.

• To cancel, press the ZERO SET MEMORY button again.

2. Stop the playback.

3. Rewind the tape.

• If the tape counter shows a negative value, fast forward the tape instead.
• The tape stops automatically at “0:00:00” and the

mark disappears.

• The tape counter changes to time code.

The zero set memory may not function correctly if the time code has not been recorded

consecutively.

The zero set memory function may not work correctly if you mix recordings in HDV and DV

standards on the same tape.

Index Search

With the index search you can locate any point you have marked beforehand with an index signal
(

74). This function is operated with the wireless controller.

1. Press the SEARCH SELECT button to display the

icon.

2. Press the

button to begin searching.

• Press more than once to search for further index signals (up to 10 times).
• Press the STOP

button to stop searching.

Playback may start slightly before or after the index signal.
The index search function may not work correctly if you mix recordings in HDV and DV standards

on the same tape.