Canon XF305 Manual De Instruções

Página de 217
Recording
46
3
Recording Video
Recording
1 Hold down the button on the d switch and move it to 
CAMERA (
0
27).
• The camcorder turns on in 
 mode and enters record pause 
mode.
• The access indicator for the CF card slot selected for recording 
illuminates in red and then changes to green.
2 Press the START/STOP button to begin recording.
• Recording starts. The front and rear tally lamps illuminate and the 
recording indicator [NREC] appears on the screen.
• You can use the START/STOP button on the side grip, handle or 
below the iris ring.
• When you use the wireless controller, press the START/STOP button 
and the record enable button simultaneously.
3 Press the START/STOP button to pause the recording.
• The clip* is recorded to the CF card and the camcorder enters record 
pause mode. The tally lamps will also go out.
* “Clip” refers to one movie unit from the point you press the START/STOP button 
to start recording until you press again to pause the recording. You can also 
include custom picture settings (0 119) and metadata (0 98) with the clip.
IMPORTANT
• Observe the following precautions while the CFj or CFl access 
indicator is illuminated in red. Failure to do so may result in permanent 
data loss.
- Do not open the CF card slot cover of the CF card slot being 
accessed and remove the CF card.
- Do not disconnect the power source or turn off the camcorder.
• Be sure to save your recordings regularly (0 158), especially after 
making important recordings. Canon shall not be liable for any loss or 
corruption of data.
NOTES
• The START/STOP button on the handle has a lock lever to prevent 
accidental operation. Set the lock lever to R in cases such as when 
you do not want a recording inadvertently paused or do not plan to use 
the START/STOP button. Return the lever to its previous position to 
enable use of the START/STOP button again.
COP
Y