Canon LV-7375 Manual De Instruções

❶

This section helps you resolve problems you may encounter while setting up or using the projector.

Off

The main power is off

–

Blinking light

Green

0.5 sec On,
0.5 sec Off

The  projector  is  getting  ready 
to turn on.

Wait for a moment.

2.5 sec On,
0.5 sec Off

Off Timer is enabled.

–

Orange

0.5 sec On,
0.5 sec Off

The projector is cooling down. Wait for a moment.

Steady light

Green

The projector is turned on.

–

Orange

The projector is in Standby.

–

Off

Normal

–

Blinking light

Red

1 cycle (0.5 sec On, 
2.5 sec Off)

L amp  cover  er ror  or  l amp 
housing error

Replace the lamp cover or lamp correctly.
See page 

2 cycle (0.5 sec On, 
0.5 sec Off)

Temperature error

The projector is overheated. Move the projector to a cooler 
location.

3 cycle (0.5 sec On, 
0.5 sec Off)

Power error 

Power unit is not working properly.
Contact your dealer

4 cycle (0.5 sec On, 
0.5 sec Off)

Fan error

Fans will not work correctly.

6 cycle (0.5 sec On, 
0.5 sec Off)

Lamp error

Lamp fails to light. Wait a full minute and then turn on 
again.

Green

Re-firing the lamp (The projec-
tor is cooling down.)

The projector is re-firing.
Wait for a moment.

Steady light

Green

Standby([Normal] for [Standby 
mode])

–

Orange

Key lock is on.

You have pressed cabinet button when Key lock is on.
See page 

Off

Normal

–

Blinking light

Red

Lamp has reached its end of life. Lamp 
replacement message will be displayed.

Replace the lamp.

Steady light

Red

Lamp has been used beyond its limit. 
The projector will not turn on until the 
lamp is replaced.

Replace the lamp.

Green

Lamp mode is set to Quiet mode.

–

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp with the 
STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:

- Unplug the power cord after the cooling fans stop.
- Move the projector to a cooler location if the room where you are presenting is particularly too warm.
- Clean the ventilation holes if they are clogged with dust.
- Wait about 60 minutes until the inside of the projector becomes cool enough.