Canon vb-s31D Guia De Utilização

[Video] Setting Video Size, Quality and Frame Rate

ting P

age

(3) [Target Bit Rate (kbps)]

If [Use bit rate control] is selected in (2), select a

desired target bit rate from the 17 levels from [64] to

[16384].

(4) [Video Quality]

If [Do not use bit rate control] is selected in (2), select

a desired quality from 1 to 5 (total 5 levels) for H.264

video transmission.

Greater values have higher quality.

(5) [Frame Rate (fps)]

Select [30], [15], [10], [6], [5], [3], [2] or [1] (fps) for

the frame rate of video transmitted.

(6) [I Frame Interval (sec)]

Select [0.5], [1], [1.5], [2], [3], [4] or [5] for the I frame

interval (sec) for H.264 video.

H.264(2)

(1) [H.264(2)]

Select [Enable] to distribute H.264 video using two

streams.

Note that H.264(2) video cannot be used for upload,

memory card recording, or RM-Lite.

Refer to the settings for “H.264(1)” for details about

[Video Size], [Bit Rate Control], [Target Bit Rate

(kbps)], [Video Quality], [Frame Rate (fps)], and [I

Frame Interval (sec)] settings.

On-screen display

(1) [Date display]

Select whether to enable date display over video. If

[Enable] is selected, date information will be

displayed over video.

(2) [Position of date display]

Select [Upper left], [Upper right], [Lower left] or

[Lower right] for the position of date display

information.

(3) [Format of date display]

Select [YYYY/MM/DD], [DD/MM/YYYY] or [MM/DD/

YYYY] for the format of the date display.

(4) [Time display]

Select whether to enable time display over video. If

[Enable] is selected, display time information will be

displayed over video.

Important

When streaming two H.264 videos, setting the video size

settings for H.264(1) and H.264(2) to the following
combinations restricts the frame rate to a maximum of 15 fps.

For all other combinations, a frame rate of up to 30 fps can be

selected.

H.264(1)

H.264(2)

1920 x 1080

All sizes

1920 x 1080

1280 x 960

1280 x 720

1280

720

Important

• When [H.264(1)] is selected for the memory card recording

and upload settings, the following restrictions apply to the
[H.264(1)] setting.

- Only [Use bit rate control] can be selected for [Bit Rate

Control].

- Only [3072] or less can be selected for [Target Bit Rate

(kbps)].

- Only one of [0.5], [1], and [1.5] can be selected for [I

Frame Interval (sec)].

• Network load will increase if a larger video size is set or

higher video quality and target bit rate are set, as this

increases data size per frame. As a result, the following could
occur:

JPEG: The frame rate may drop

H.264: Video may be temporarily disrupted

• Block noise may become noticeable if a large video size and

low target bit rate are set.

• The data size may increase depending on the type or

movement of the subject. If the frame rate remains low or

other undesirable conditions continue for a prolonged

period, lower the video size or quality setting.

• Note that if you are using included RM-Lite, the hard disk

usage will also be affected during recording.

• H.264 video can be displayed using Admin Viewer and RM-

Lite. However, it cannot be displayed using VB Viewer.