Canon vb-s31D Manual
165
6
Appe
ndi
x
x
Messages Displayed in the Information Field
Messages displayed in the information field of the viewer are classified into the following three types.
Information Messages
Warning Messages
List of Viewer Messages
Icon
Category
Explanation
Information Message
Help messages on various buttons, pull-down lists, etc., as well as frame rate and other
information from the camera are shown.
information from the camera are shown.
Warning Message
A message will be displayed notifying the user when camera control privileges cannot
be obtained, the audio session stops, etc.
be obtained, the audio session stops, etc.
Error Message
Displayed when a system error occurs in the viewer.
Message
Explanation
Connection closed by the camera.
The camera was disconnected.
Audio connection has been closed.
The video session has continued after the audio session was disconnected.
Camera control gained.
Displayed when camera control is obtained. You can operate the camera.
Camera control lost.
Displayed when camera control is released. You cannot operate the camera
until you get camera control privileges again.
until you get camera control privileges again.
Use the menu displayed by right-clicking to exit the full
screen mode.
screen mode.
When switched to full screen mode
Recording to memory card aborted.
When recording to memory card was completed successfully
The connection was terminated because the password
has been changed.
has been changed.
When the password of the account used to connect to the camera was
changed during camera connection and then any WV-HTTP command was
issued
changed during camera connection and then any WV-HTTP command was
issued
Message
Explanation
{n}fps Pan: {p} Tilt: {t} Zoom: {z}
Communicating with the camera normally
The connection was terminated because the image has
been flipped.
been flipped.
When the video was flipped during camera connection (camera connection
is terminated when a video is flipped)
is terminated when a video is flipped)
Message
Explanation
{n}fps Pan: {p} Tilt: {t} Zoom: {z}
Communicating with the camera normally (when Digital PTZ is enabled)
{n}fps
Communicating with the camera normally (when Digital PTZ is disabled)
Message
Explanation
Could not connect to the camera.
Connection failed due to an invalid IP address, etc.
The camera is busy.
The connection limit was exceeded.