Canon LX-MU500 Manual
67
ENGLIS
H
Timing of replacing the lamp
When the lamp indicator lights up red or a message appears suggesting it is time to replace the lamp,
please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector
and in some instances the lamp may explode.
The LAMP indicator light and TEMPerature indicator light will light up if the lamp becomes too hot.
Turn the power off and let the projector cool for 45 minutes. If the Lamp or TEMPerature indicator
light still lights up after turning the power back on, please contact your dealer. See
for details.
The following lamp warning displays will remind you to change the lamp.
Status
Message
The lamp has been in operation for 1500 hours. Install a new lamp
for optimal performance. If the projector is normally run with
Economic selected (See
), you may continue to operate the projector until the 1950 hour
lamp warning appears.
The lamp has been in operation for 1950 hours. A new lamp should
be fitted to avoid the inconvenience when the projector runs out of
lamp time.
The lamp has been in operation for 2000 hours.
It is strongly recommended that you replace the lamp at this age.
It is strongly recommended that you replace the lamp at this age.
The lamp is a consumable item. The lamp brightness
diminishes with use. This is normal lamp behavior. You can
replace the lamp whenever you notice that the brightness
level has significantly diminished. If the lamp is not
replaced beforehand, it must be replaced after 2000 hours
usage.
The lamp MUST be replaced before the projector will operate
normally.
Notice
Order Replacement Lamp
Lamp>1500 Hours
OK
Notice
Replace Lamp Soon
Lamp>1950 Hours
OK
Notice
Replace Lamp Now
Lamp>2000 Hours
OK
WARNING
Out of Lamp Usage Time
Replace lamp (Refer to user manual)
Then reset lamp timer
OK