Canon DP-V3010 Manual

25

Operating the Display Controller

The display controller allows you to easily adjust the input signal settings and image quality. In addition, you can assign
the frequently used functions to dedicated buttons.

Adjusting the Image Quality

1.  Adjust the image quality by rotating each knob.

Use the slider that appears at the bottom of the screen as guide.
•  SHARPNESS

Adjusts the sharpness of the image.

•  CHROMA

Adjusts the color saturation of the image.

•  BRIGHTNESS

Adjusts the black level of the image.

•  CONTRAST

Adjusts the white level of the image.

Adjusting the Image Quality on CDL

1.  Switch the CDL select switch to CDL.

2.  Use the RGB select button to select the color to adjust.

3.  Adjust the image quality by rotating each knob.

•  POWER

Adjusts the gamma of the image.

•  SATURATION

Adjusts the color saturation of the image.
RGB cannot be selected for SATURATION.

•  OFFSET

Adjusts the black level of the image.

•  SLOPE

Adjusts the white level of the image.

Note

•  Press the RESET button above the relevant adjustment, to return to factory default. In "User 1-7" mode where you are

performing calibration, the setting returns to the value after calibration instead of the factory default.

•  Warming-up is necessary to stabilize the brightness of the video display. Wait at least 10 minutes after turning on the power

before using.

•  If no operation is performed for approximately 1 minute, OSD menu will disappear automatically. The slider will disappear

automatically if no operation is performed for approximately 10 seconds.

•  The settings that cannot be set, are grayed out.

Item

Setting options (underline indicates the 

factory default)

POWER

0.50 to 4.00 (1.00) (Increments of 0.01)

SATURATION

0.000 to 2.000 (1.000) (Increments of 0.001)

OFFSET

-1.000 to 1.000 (0.000) (Increments of 0.001)

SLOPE

0.000 to 2.000 (1.000) (Increments of 0.001)