ASUS B85M-G Manual Do Utilizador

1-20

Chapter 1: Product introduction

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect 

one end of the chassis intrusion sensor or switch cable to this connector. The chassis 

intrusion sensor or switch sends a high-level signal to this connector when a chassis 

component is removed or replaced. The signal is then generated as a chassis intrusion 

event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper 

cap. Remove the jumper caps only when you intend to use the chassis intrusion 

detection feature.

+5VSB_MB

Chassis Signal GND

CHASSIS

Standby Power LED
The motherboard comes with a standby power LED that lights up to indicate that the 

system is ON, in sleep mode, or in soft-off mode. This is a reminder that you should 

shut down the system and unplug the power cable before removing or plugging in any 

motherboard component. The illustration below shows the location of the onboard LED.

SB_PWR

Standby Power Powered Off