ASUS P8B75-M LE Manual Do Utilizador

2-19

ASUS P8B75-M LE Series

Allows you to enable or disable the Intel(R) Rapid Start Technology. 

Configuration options: [Enabled] [Disabled]

The following three items appear only when you set the Intel(R) Rapid Start Technology 

to [Enabled].

Entry on S3 RTC Wake [Enabled]

Allows you to enable or disable the iFFS invocation upon S3 RTC wake. Configuration options: 

[Enabled] [Disabled]
Entry After [10 Minutes]

This item appears only when you set the Entry on S3 RTC Wake to [Enabled] and allows you to 

set the RTC wake timer at S3 entry. Configuration options: [Immediately] [1 minute] [2 minute] [5 

minute] [10 minute] [15 minute] [30 minute] [1 hour] [2 hours]
Active Page Threshold Support [Disbaled]

Allows you to enable or disable the Active Page Threshold Support. Configuration options: 

[Enabled] [Disabled]
Active Memory Threshold [x]

This item appears only when you set the Active Page Threshold Support to [Enabled] and allows 

you to set the Active Memory Threshold. When the partition size is larger than the Active Page 

Threshold size, the system will try to support the Intel(R) Rapid Start Technology. When the item is 

set to zero, the system automatically checks whether the partition size is enough at S3 entry. Key in 

the desired value using the numeric keypad.

ISCT Configuration [Disabled]

Allows you to enable or disable the ISCT configuration. Configuration options: [Enabled] [Disabled]

While entering Setup, the BIOS automatically detects the presence of SATA devices. The 

SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.

Allows you to set the SATA configuration.
[IDE] 

 Set to [IDE] when you want to use the Serial ATA hard disk drives as 

Parallel ATA physical storage devices.

[AHCI] 

 Set to [AHCI] when you want the SATA hard disk drives to use the AHCI 

(Advanced Host Controller Interface). The AHCI allows the onboard storage 

driver to enable advanced Serial ATA features that increases storage 

performance on random workloads by allowing the drive to internally 

optimize the order of commands.

S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When 

read/write of your hard disk errors occur, this feature allows the hard disk to report warning 

messages during the POST. Configuration options: [Enabled] [Disabled]

This item only appears when you set the SATA Mode Selection item to [AHCI] and allows you 

to enable or disable the hot-plug support for each SATA port. Configuration options: [Enabled] 

[Disabled]