QLogic 7104-7M-CABLE Manual Do Utilizador
IB0056101-00 H
7-1
7
Installation Verification and
Additional Settings
Additional Settings
This section provides instructions for verifying that the software has been properly
installed, the drivers are loaded, and that the fabric is active and ready to use.
Information on adapter performance tuning is also provided.
installed, the drivers are loaded, and that the fabric is active and ready to use.
Information on adapter performance tuning is also provided.
LED Link and Data Indicators
The LEDs function as link and data indicators once the InfiniPath software has
been installed, the driver has been loaded, and the fabric is being actively
managed by a subnet manager.
been installed, the driver has been loaded, and the fabric is being actively
managed by a subnet manager.
Table 7-1
describes the LED states. The green LED indicates the physical link
signal; the amber LED indicates the link. The green LED normally illuminates first.
The normal state is Green On, Amber On. The QLE7240 and QLE7280 have an
additional state, as shown in
The normal state is Green On, Amber On. The QLE7240 and QLE7280 have an
additional state, as shown in
Table 7-1
.
Table 7-1. LED Link and Data Indicators
LED States
Indication
Green OFF
Amber OFF
Amber OFF
The switch is not powered up. The software is neither
installed nor started. Loss of signal.
Verify that the software is installed and configured with
ipath_control -i. If correct, check both cable con-
installed nor started. Loss of signal.
Verify that the software is installed and configured with
ipath_control -i. If correct, check both cable con-
nectors.
Green ON
Amber OFF
Amber OFF
Signal detected and the physical link is up. Ready to talk
to SM to bring the link fully up.
If this state persists, the SM may be missing or the link
may not be configured.
Use ipath_control -i to verify the software state. If
to SM to bring the link fully up.
If this state persists, the SM may be missing or the link
may not be configured.
Use ipath_control -i to verify the software state. If
all host channel adapters are in this state, then the SM is
not running. Check the SM configuration, or install and
run opensmd.
not running. Check the SM configuration, or install and
run opensmd.