Canon Océ VarioPrint 6000+ Series Manual
Step
Action
Information
3
Loosen the trimmer infeed convey-
or.
or.
The procedure can be seen from the top
of the machine.
Access to the parts is through the for-
mer-clamp mechanism.
Hold the shaft and push to the right,
against spring pressure to disengage the
shaft from the drive pin.
of the machine.
Access to the parts is through the for-
mer-clamp mechanism.
Hold the shaft and push to the right,
against spring pressure to disengage the
shaft from the drive pin.
Lift the left hand end clear.
4
Remove the book, if one is found.
5
Remove any paper offcuts from the
trimmer infeed conveyor.
trimmer infeed conveyor.
Look down through the former clamp.
Small pieces of paper trimmings can
cover the jam sensor and cause an error
message.
Small pieces of paper trimmings can
cover the jam sensor and cause an error
message.
6
Fit the trimmer infeed conveyor.
Look down through the former clamp.
• Insert the right hand end of the shaft
• Insert the right hand end of the shaft
into the bearing, against the spring
pressure.
pressure.
• Rotate the trimmer infeed conveyor,
so that the green belts are vertical.
• Insert the left-hand end, so that the
shaft engages with the drive pin.
7
Fit the trim bin.
8
Close the Booklet maker main deck
and covers.
and covers.
Jam before the Trimmer
92
Chapter 6 - Error Conditions, Problems and Solutions