Canon PowerShot N100 White Manual
189
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
Modes
P Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Hybrid Auto /
Dual Capture Mode
Dual Capture Mode
Naming error!
•
The folder could not be created or images could not be recorded, because the highest
supported folder number (999) for storing images on the card has been reached and
the highest supported image number (9999) for images in folders has been reached.
On the [
supported folder number (999) for storing images on the card has been reached and
the highest supported image number (9999) for images in folders has been reached.
On the [
Lens Error
•
This error may occur if the lens is held while it is moving, or when the camera is used
in dusty or sandy locations.
in dusty or sandy locations.
•
Frequent display of this error message may indicate camera damage. In this case,
contact a Canon Customer Support Help Desk.
contact a Canon Customer Support Help Desk.
A camera error was detected (error number)
•
If this error message is displayed immediately after a shot, the image may not have
been saved. Switch to Playback mode to check for the image.
been saved. Switch to Playback mode to check for the image.
•
Frequent display of this error message may indicate camera damage. In this case,
write down the error number (Exx) and contact a Canon Customer Support Help
Desk.
write down the error number (Exx) and contact a Canon Customer Support Help
Desk.
File Error
•
Correct printing (
images that have been altered using computer software, even if the camera is
connected to the printer.
connected to the printer.
Print error
•
Check the paper size setting (
setting is correct, restart the printer and complete the setting on the camera again.
Ink absorber full
•
Contact a Canon Customer Support Help Desk to request assistance with ink
absorber replacement.
absorber replacement.
Wi-Fi
Connection failed
•
No access points were recognized. Check the access point settings (
•
A device could not be found. Turn the camera off and on again, and retry the
connection.
connection.
•
Check the device you want to connect to and make sure it is ready for connection.
Cannot determine access point
•
The WPS buttons on numerous access points were pressed simultaneously. Try
reconnecting again.
reconnecting again.
No access points found
•
Check to make sure that the access point is turned on.
•
When connecting to an access point manually, make sure that you entered the
correct SSID.
correct SSID.
Incorrect password/Incorrect Wi-Fi security settings
•
Check the access point security settings (
IP address conflict
•
Reset the IP address so that it does not conflict with another.
Disconnected/Receiving failed/Sending failed
•
You may be in an environment where Wi-Fi signals are obstructed.
•
Avoid using the camera’s Wi-Fi function around microwave ovens, Bluetooth devices,
and other devices that operate on the 2.4 GHz band.
and other devices that operate on the 2.4 GHz band.
•
Bring the camera closer to the other device you are trying to connect to (such as the
access point), and make sure there are no objects between the devices.
access point), and make sure there are no objects between the devices.
•
Check the connected device to make sure it is not experiencing errors.