Canon EOS-1D X Mark II Manual

27

To connect using an access point, check if the access point supports 
WPS

*

 that allows easy connection between Wi-Fi devices.

If you do not know if the access point you use is WPS-compatible, refer 
to the access point instruction manual or other documentation.

* Wi-Fi Protected Setup



When WPS is supported
The following two connection methods are available. Connection 
can be established easier with WPS (PBC mode).
• Connecting via WPS (PBC mode): Perform the operations 

described on page 28.

• Connecting via WPS (PIN mode): Perform the operations 

described on page 29.



When WPS is not supported
• Connecting to a detected network manually: Perform the 

operations described on page 31.

The transmitter supports the following options for [Authentication] and 
[Encryption settings]. Therefore, when connecting to a detected 
network manually, the encryption used by the access point must be one 
of the following.



[Authentication]: Open system, Shared key, or WPA/WPA2-PSK



[Encryption settings]: WEP, TKIP, or AES





When connecting to a network that has a network administrator, ask the 
administrator about the detailed setting procedures.

If the network you use filters by MAC address, register the MAC address of 
the transmitter at the access point. The MAC address can be checked on 
the [Function settings] screen (p.114).