Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Manual Do Equipamento

Insert the new fan tray module into the fan tray module slot, and gently push the module 

into the slot. 

Align the two captive screws with the screw holes in the switch’s back panel. 

Using a screwdriver, gently tighten the captive screws.

Connecting Equipment to the Switch

You can connect devices or a 100M/1G/10G module to the switch. 

RJ-45 Ports

The switch uses Auto Uplink technology, which enables you to attach devices using either 
straight-through or crossover cables. Use a Category 5 (Cat5) unshielded twisted-pair (UTP) 
cable terminated with an RJ-45 connector for 100/1000M and use a Category 6a (Cat6a) 
cable terminated with an RJ45 connector for 10G. 

Ethernet specifications limit the cable length between the switch and 
the attached device to 328 feet (100 meters).

Connecting a Console to the Switch

After you install the switch and apply power, you can connect to it with a terminal or 
workstation. You can use the Command Line Interface (CLI) to identify the IP address. 

To use a console you need the following items:

VT100/ANSI terminal, or a Windows PC, Apple Macintosh PC, or UNIX workstation.

USB console cable (shipped with the product) or a Null-modem cable with 9-pin 

connectors on each end.