Netgear R7500v2 - Nighthawk Dual Band Gigabit Wireless Router - 802.11ac Manual Do Utilizador

This section describes tips for troubleshooting some common problems.

Turn off and unplug the modem.

Turn off the router.

Plug in the modem and turn it on. Wait two minutes.

Turn on the router and wait two minutes.

If your device does not power on, make sure that the Ethernet cables are securely plugged in. The Internet
LED on the router is lit if the Ethernet cable connecting the router and the modem is plugged in securely
and the modem and router are turned on. If one or more powered-on computers are connected to the
router by an Ethernet cable, the corresponding numbered router LAN port LED lights.

Make sure that the wireless settings in the computer and router match exactly. The wireless network name
(SSID) and wireless security settings of the router and wireless computer must match exactly.

If you set up an access list in the Advanced Wireless Settings page, you must add each wireless computer’s
MAC address to the router’s access list.

Make sure that the network settings of the computer are correct. Wired and wirelessly connected computers
must use network (IP) addresses on the same network as the router. The simplest way to do this is to
configure each computer to obtain an IP address automatically using DHCP.

Some cable modem service providers require you to use the MAC address of the computer initially
registered on the account. You can view the MAC address on the Attached Devices page.

By default, the router is set with standard LED settings. If you turned off the LEDs except the Power LED,
you must return the LEDs to their standard settings for troubleshooting. For information about controlling
the LED settings, see 

 on page 12.