Netgear WC7520 - ProSafe 20-AP Wireless Controller Manual De Referência
Monitoring the Wireless Network and Components
169
ProSafe 20-AP Wireless Controller WC7520
Local Device IP
The local IP address of a primary controller in a redundancy group. This IP address
remains assigned to the primary controller and is not transferred to the secondary
controller if a failover occurs. This allows the primary controller to be identified
before and after a failover.
remains assigned to the primary controller and is not transferred to the secondary
controller if a failover occurs. This allows the primary controller to be identified
before and after a failover.
Controller Status
The state of the wireless controller (Up or Down).
Secondary IP
The IP address of the secondary controller in a redundancy group.
Active Controller
The active controller in a redundancy group (Primary or Secondary).
Backup Status
The status of the secondary controller in a redundancy group (Reachable or Not
reachable).
reachable).
Sync Status
The synchronization status between the wireless controllers in a redundancy group
(In Sync or Not in Sync).
(In Sync or Not in Sync).
Network Status section
For each wireless controller, access point, and client, the following information displays:
Total
Up
The total number of managed devices that are running correctly.
Down
The total number of managed devices that cannot be pinged.
Alarms
Critical
The wireless controller can ping these managed devices, but either cannot log in or
has detected that these device are different from the ones that were configured.
has detected that these device are different from the ones that were configured.
Major
The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
Wireless Clients section
For each wireless controller and wireless client, the following information displays:
Controller
The IP address of the wireless controller that manages the access points to which
the wireless clients are connected.
the wireless clients are connected.
Open
The number of wireless clients that are connected to managed access points using
security profiles configured with open mode.
security profiles configured with open mode.
WEP
The number of wireless clients that are connected to managed access points using
security profiles configured with WEP.
security profiles configured with WEP.
WPA
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA.
security profiles configured with WPA.
WPA2
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA2.
security profiles configured with WPA2.
Table 39. Network summary information (continued)
Item
Description