Netgear WC7520 - ProSafe 20-AP Wireless Controller Manual De Referência
Introduction and Overview
26
ProSafe 20-AP Wireless Controller WC7520
Deploy the Wireless Controller
To deploy the wireless controller:
1.
Disconnect the wireless controller from the computer and place it where you will deploy
it. If necessary, you can now reconfigure the computer that you used in the configuration
process back to its original TCP/IP settings.
it. If necessary, you can now reconfigure the computer that you used in the configuration
process back to its original TCP/IP settings.
2.
Connect an Ethernet cable from your wireless controller to a LAN port on your network.
3.
Connect the power cord to the wireless controller and plug the power cord into a power
outlet. The Power, Test, and Ethernet LEDs should light up. If any of these do not light up,
see
outlet. The Power, Test, and Ethernet LEDs should light up. If any of these do not light up,
see