Netgear WC7600v1 - ProSAFE Wireless Controller Manual Do Utilizador

The following figure shows a close-up of the left side of the front panel.

From left to right, the front panel of models WC7500 and WC7600v2 show the components 
that are described in the following table.

Digital counter

Displays the number of connected access points that are in a healthy state.

System LEDs

From top to bottom: Power LED, Status LED, Fan LED, and Stack Master LED. 
These LEDs are described in 

Ethernet ports and LEDs Four 10/100/1000 Mbps LAN Ethernet port with an RJ-45 connector, left LED, and 

right LED. The Ethernet port provides switched N-way, automatic speed negotiating, 
auto MDI/MDIX technology.

USB ports

Two USB 2.0 ports for external storage of floor heat maps, saving of the syslogs, and 
backing up the configuration. The USB ports support FAT32 file systems.

SD card slot

An SD card for saving of the system logs will be supported in a future release.

Console port

RS232 port for connecting to an optional console terminal. The port provides a DB9 
male connector. The default baud rate is 115200 bits/second. 

The console port is for debugging under guidance of NETGEAR technical 

support only.

Reset button

Using a sharp object, press and hold this button for about 10 seconds until the Status 
LED blinks and the wireless controller returns to factory default settings. 

If you reset the wireless controller, all configuration settings are lost and the default 
password is restored.

LEDs (top to bottom):

Power, Status, Fan, Stack Master

 

Digital access point counter

10/100/1000M RJ-45 ports

 

and LEDs

USB ports