Netgear FWG114Pv1 – Wireless Firewall with USB Print Server Manual De Referência

3-16

Connecting the FWG114P to the Internet

Note:  You can validate modem string settings by first connecting the modem directly to a 
computer, establishing a connection to your ISP, and then copying the modem string 
settings from the computer configuration and pasting them into the FWG114P Modem 
Properties Initial String field. For more information on this procedure, please refer to the 
support area of the NETGEAR Web site.

•

Select the Serial Line Speed. This is the maximum speed the modem will attempt to 
use. For ISDN permanent connections, the speeds are typically 64000 or 128000 bps. 
For dial-up modems, 56000 bps would be a typical setting.

•

Select the Modem Type:

–

For ISDN, select “Permanent connection (leased line).”

–

For dial-up, select your modem from the list. “Standard Modem” should work in 
most cases.

–

If your modem is not on the list, select “User Defined” and enter the Modem 
Properties.

Note:  If you are using the “User Defined” Modem Type, you must first use the Serial Port 
menu Modem link to fill in the Modem Properties settings for your modem. 

e.

Click Apply to save your settings.

3.

a.

If you have a broadband connection, disconnect it.

b.

From a workstation, open a browser and test your serial port Internet connection.

Note:  The response time of your serial port Internet connection will be slower than a 
broadband Internet connection.

After completing the Internet connection configuration, your can test your Internet connection. 
Log in to the firewall, then, from the Setup Basic Settings link, click the Test button. If the 
NETGEAR Web site does not appear within one minute, refer to 

.”

Popup blocking software may block the test page from opening. Alternately, you can just 

open a new browser window and browse the Internet.

To access the Internet from any computer connected to your firewall, launch a browser, such as 
Microsoft Internet Explorer or Netscape Navigator. You should see the firewall’s Internet LED 
blink, indicating communication to the ISP. The browser should begin to display a Web page.