Netgear FWG114Pv2 – Wireless Firewall with USB Print Server Guia Da Instalação

)NSTALLATION

Please refer to the Reference Manual on your CD for instructions on advanced 
configuration options. 
Estimated Completion Time: 20 minutes.

•

For Cable Modem Service: When you set up the wireless firewall/print server, be sure 
to use the computer you first registered with your cable modem service provider.

•

For DSL Service:You may need information such as the DSL login name and 
password in order to complete the wireless firewall/print server setup.

a.

Turn off and unplug your cable or DSL modem.

b. Turn off your computer.
c.

At the computer end 
only, disconnect the 
Ethernet cable (point A 
in the illustration) that 
connects your computer 
to the cable or DSL 
modem.

0RGHP

,QWHUQHW

&RPSXWHU

d. Securely insert the Ethernet cable 

from your modem into the 
FWG114P v2 Internet port (point 
B in the illustration).

e.

Securely insert one end of the 
blue NETGEAR cable that came 
with your FWG114P v2 into a 
Local port on the router such as 
port 4 (point C in the 
illustration), and the other end into the Ethernet port of your computer (point D in 
the illustration).

Warning: Failure to restart your network in the correct sequence could prevent you 
from connecting to the Internet.
a.

First, plug in and turn on the cable or DSL modem.Wait about 2 minutes.

b. Now, plug in the power cord to your FWG114P v2 and wait about 30 seconds. 
c.

Last, turn on your computer. 
Note: For DSL customers, if ISP provided software logs you in to the Internet, do 
not run that software. You may need to go to the Internet Explorer® Tools menu, 
Internet Options, Connections tab page where you can select the “Never dial a 
connection” radio button and click Apply.

d. Check the status lights and verify the following:

0RGHP

,QWHUQHW

):*3Y

,QWHUQHW

0RGHP

):*3Y

&RPSXWHU

•

Power: The power light should be lit. If after 2 minutes the power light turns 
solid amber, see the Troubleshooting Tips in this guide.

•

Test: The test light blinks when the the FWG114P v2 is first turned on. If 
after 2 minutes it is still on, see the Troubleshooting Tips in this guide.

•

Internet: The Internet light on the FWG114P v2 should be lit. If not, make 
sure the Ethernet cable is securely attached to the wireless firewall/print 
server Internet port and the powered on modem.

•

Wireless: The WLAN light should be lit. If the Wireless light is not lit, see 
the Troubleshooting Tips in this guide.

•

LOCAL: A LOCAL light should be lit. 

a.

On the computer connected to the FWG114P v2, open a browser such as Internet 
Explorer or Netscape® Navigator.

b. Type http://192.168.0.1 in your browser and click Enter. 

If you did not connect to the router, verify that your computer is set up for DHCP. 
For help with this, please see the animated tutorials on the CD or Appendix C of 
the Reference Manual.

c.

When prompted, enter admin

 for the router user name and password for the 

router password, both in lower case letters.

d. After logging in, you will see the Setup Wizard on the FWG114P v2 settings 

main page.

P R I N TER

M O D EM

I N TER N ET

LO CA L

W LA N