Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Programa
Utility Commands
171
M5300, M6100, and M7100 Series ProSAFE Managed Switches
The commands in this chapter are in one of four functional groups:
•
Show commands. Display switch settings, statistics, and other information.
•
Configuration commands. Configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
configuration command, there is a show command that displays the configuration setting.
•
Copy commands. Transfer or save configuration and informational files to and from the
switch.
switch.
•
Clear commands. Clear some or all of the settings to factory defaults.
AutoInstall Commands
The AutoInstall feature enables the automatic update of the image and configuration of the
switch. This feature enables touchless or low-touch provisioning to simplify switch
configuration and imaging.
switch. This feature enables touchless or low-touch provisioning to simplify switch
configuration and imaging.
AutoInstall includes the following support:
•
Downloading an image from TFTP server using DHCP option 125. The image update can
result in a downgrade or upgrade of the firmware on the switch.
result in a downgrade or upgrade of the firmware on the switch.
•
Automatically downloading a configuration file from a TFTP server when the switch is
booted with no saved configuration file.
•
Automatically downloading an image from a TFTP server in the following situations:
-
When the switch is booted with no saved configuration found.
-
When the switch is booted with a saved configuration that has AutoInstall enabled.
When the switch boots and no configuration file is found, it attempts to obtain an IP address
from a network DHCP server. The response from the DHCP server includes the IP address of
the TFTP server where the image and configuration flies are located.
from a network DHCP server. The response from the DHCP server includes the IP address of
the TFTP server where the image and configuration flies are located.
After acquiring an IP address and the additional relevant information from the DHCP server,
the switch downloads the image file or configuration file from the TFTP server. A downloaded
image is automatically installed. A downloaded configuration file is saved to non-volatile
memory.
image is automatically installed. A downloaded configuration file is saved to non-volatile
memory.
Note:
AutoInstall from a TFTP server can run on any IP interface, including
the network port, service port, and in-band routing interfaces (if
supported). To support AutoInstall, the DHCP client is enabled
operationally on the service port, if it exists, or the network port, if
there is no service port.
supported). To support AutoInstall, the DHCP client is enabled
operationally on the service port, if it exists, or the network port, if
there is no service port.