Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Programa
Switching Commands
422
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Provisioning (IEEE 802.1p) Commands
This section describes the commands you use to configure provisioning (IEEE 802.1p,)
which allows you to prioritize ports.
which allows you to prioritize ports.
vlan port priority all
This command configures the port priority assigned for untagged packets for all ports
presently plugged into the device. The range for the priority is 0-7. Any subsequent per port
configuration will override this configuration setting.
presently plugged into the device. The range for the priority is 0-7. Any subsequent per port
configuration will override this configuration setting.
vlan priority
This command configures the default 802.1p port priority assigned for untagged packets for a
specific interface. The range for the priority is 0–7.
specific interface. The range for the priority is 0–7.
Asymmetric Flow Control
Note:
Asymmetric Flow Control is not supported on Fast Ethernet platforms.
Note:
If Asymmetric Flow Control is not supported on the platform, then only
symmetric, or no flow control, modes are configurable.
symmetric, or no flow control, modes are configurable.
When in asymmetric flow control mode, the switch responds to PAUSE frames received from
a peer by stopping packet transmission, but the switch does not initiate MAC control PAUSE
frames.
a peer by stopping packet transmission, but the switch does not initiate MAC control PAUSE
frames.
When you configure the switch in asymmetric flow control (or no flow control mode), the
device is placed in egress drop mode. Egress drop mode maximizes the throughput of the
system at the expense of packet loss in a heavily congested system, and this mode avoids
head-of-line blocking.
device is placed in egress drop mode. Egress drop mode maximizes the throughput of the
system at the expense of packet loss in a heavily congested system, and this mode avoids
head-of-line blocking.
Format
vlan port priority all priority
Mode
Global Config
Default
0
Format
vlan priority priority
Mode
Interface Config