Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Programa
IPv6 Commands
931
M5300, M6100, and M7100 Series ProSAFE Managed Switches
If you do not specify a tunnel ID, the command shows the following information for each
configured tunnel.
configured tunnel.
If you specify a tunnel ID, the command shows the following information for the tunnel.
Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
668. To assign an
interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0 to 7.
the loopback ID is 0 to 7.
Term
Definition
Tunnel ID
The tunnel identification number.
Interface
The name of the tunnel interface.
Tunnel Mode
The tunnel mode.
Source Address
The source transport address of the tunnel.
Destination
Address
The destination transport address of the tunnel.
Term
Definition
Interface Link
Status
Status
Shows whether the link is up or down.
MTU Size
The maximum transmission unit for packets on the interface.
IPv6
Address/Length
If you enable IPv6 on the interface and assign an address, the IPv6 address and prefix display.
Format
interface loopback loopback-id
Mode
Global Config