Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Administrador
MLAGs
100
Managed Switches
Traffic Through an MLAG Is Not Forwarded Normally
If the traffic is not forwarded normally, check if the following settings are identical on the
primary and slave devices.
primary and slave devices.
•
FDB entry aging timers
•
Static MAC entries.
•
ACL configuration
A Ping to a VRRP Virtual IP Address Fails
If you ping the VRRP virtual IP address and do not see the response, use the CLI or web
management interface to check if the accept mode is enabled. By default, the accept mode is
disabled. It should be enabled before you ping the VRRP virtual IP address.
management interface to check if the accept mode is enabled. By default, the accept mode is
disabled. It should be enabled before you ping the VRRP virtual IP address.
CLI: Check the Accept Mode
1.
Check the accept mode.
(Netgear Switch) #show ip vrrp interface vlan 100 1
Primary IP address............................. 192.168.100.3
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 1
Configured Priority............................ 1
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Enable
Accept Mode.................................... Disable
State.......................................... Initialized
2.
Enable the accept mode.
(Netgear Switch) (Interface vlan 100)#ip vrrp 1 accept-mode