Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Administrador
Switch Stacks
494
Managed Switches
Renumber Stack Members
This example is provided as CLI commands and a web interface procedure.
CLI: Renumber Stack Members
Note:
When you issue a command such as move management or
renumber
renumber
, NETGEAR recommends that you wait until the command
fully executes before issuing the next command. For example, after
you issue a reset command for a stack member, issue the show
port
you issue a reset command for a stack member, issue the show
port
command to verify that the switch remerged with the stack and
that all ports joined before you issue a next command.
•
If specific numbering is required, NETGEAR recommends that you assign stack members
their numbers when they are first installed and configured in the stack.
their numbers when they are first installed and configured in the stack.
•
If the stack unit number for a switch is unused, you can renumber the unit by issuing the
switch <oldunit-id> renumber <newunit-id>
switch <oldunit-id> renumber <newunit-id>
global config mode command.
•
If you preconfigured the new unit ID, you might need to remove the new unit ID from the
configuration before renumbering the unit.
configuration before renumbering the unit.
•
If you need to reassign multiple existing stack unit numbers, the configuration could
become mismatched. To avoid this situation, NETGEAR recommends that you power
down all switches except the master, and then add them back one at a time (see
become mismatched. To avoid this situation, NETGEAR recommends that you power
down all switches except the master, and then add them back one at a time (see
To renumber stack members, issue the following CLI command:
(Netgear Switch) (Config)#switch 3 renumber 2
All the switches in the stack will be reset to perform Manager unit renumbering and
the configuration of Manager switch interfaces will be cleared.
the configuration of Manager switch interfaces will be cleared.
Are you sure you want to renumber? (y/n) y