Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Management Commands
161
M4200 and M4300 Series ProSAFE Managed Switches
no set clibanner
Use this command to unconfigure the prelogin CLI banner.
OpenFlow Commands
OpenFlow commands enable you to manage the switch from a centralized OpenFlow
controller, using the OpenFlow protocol.
controller, using the OpenFlow protocol.
openflow enable
This command enables OpenFlow.
no openflow enable
This command disables OpenFlow.
openflow static-ip
This command specifies the static IP address that must be used for OpenFlow. This static IP
address is applied only when the static IP mode is enabled. For the static IP address to be
used for OpenFlow, the switch must include an operational IP interface with the specified
address. If the switch does not include an interface with a matching IP address, OpenFlow is
operationally disabled.
address is applied only when the static IP mode is enabled. For the static IP address to be
used for OpenFlow, the switch must include an operational IP interface with the specified
address. If the switch does not include an interface with a matching IP address, OpenFlow is
operationally disabled.
If OpenFlow is enabled when you enter this command and you specify a static IP address
that is not the same as the IP address that is already in use, OpenFlow is automatically
disabled and reenabled.
that is not the same as the IP address that is already in use, OpenFlow is automatically
disabled and reenabled.
Format
no set clibanner
Mode
Global Config
Default
Disabled
Format
openflow enable
Mode
Global Config
Format
no openflow enable
Mode
Global Config
Default
0.0.0.0
Format
openflow static-ip ipv4-address
Mode
Global Config